fanuc program transfer tool instructions

ISkysoft Phone Transfer is an easy-to-use phone to phone transfer tool for Windows users. Set the DNC software to 4800, 2stop,ISO 1, even, Xon/Xoff, 7 length. Help with file transfer from Fanuc Om-c to PC I downloaded One CNC DNC software and set it up via 25 pin RS232.

The program is now loaded in the › 〓 Fanuc Program Transfer Tool 〓.

Make sure you call up the proper program to run or you will crash. Beware the program last read is the program that will run if you hit cycle start.

If program is read properly you will see the program called into memory.

Type O# (Whatever the file name is that you wish to load into machine).

Make sure you also copy the start code and end code in the backup file. Note: If you are going to load a backup file with all of the programs in one file, you may want to create a new text file and copy only the program you wish to restore.

IF YOU SCREW UP AT ANY TIME WITHIN THE PROCEDURE PRESS RESET KEY AND START OVER Load program from ATA/SRAM/PC-card to machine. All programs are output in a single text file on the PC Card.

Do not forget to call up both heads if it is a double sided control.

Make sure you call up the correct program you want to run in the machine IMMEDIATELY or you will crash the machine.

Beware the program last punched will be called up into the memory. ”OUTPUT” in corner of screen as you press the “EXEC” Soft Key.

Type O-9999 (For output of all programs, Note: don’t forget the minus sign between the O and numbers) or For single program output type O# (Where # equals the program number you wish to output).

Select Head 1 or 2 If control has two sides.

IF YOU MESS UP AT ANY TIME WITHIN THE PROCEDURE, PRESS RESET KEY AND START OVER Load program from machine to ATA/SRAM/PC-card DO NOT FORCE IT, IT WILL ONLY GO ONE WAY.

With control power “OFF” insert the PC-card into the slot to the left of the LCD display.

Setting machine to read from ATA- SRAM or PC-card Get them all from the CNC Specialty Store Need some RS232 cables, SRAM Backup cards and more? Controls with overlays from the machine tool builder may vary. This procedure will work on straight Fanuc controls. (May also work on some of the other Fanuc controls)

Fanuc program transfer tool instructions